cm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 6 days agoBambu Lab’s Controversial ‘Authorization Control’ Hits Budget 3D Printersall3dp.comexternal-linkmessage-square24fedilinkarrow-up175arrow-down11
arrow-up174arrow-down1external-linkBambu Lab’s Controversial ‘Authorization Control’ Hits Budget 3D Printersall3dp.comcm0002@lemmy.world to 3DPrinting@lemmy.worldEnglish · 6 days agomessage-square24fedilink
minus-squareBronzie@sh.itjust.workslinkfedilinkEnglisharrow-up2·6 days agoI did this, but experienced a lot of issues connecting to it afterwards. Constant disconnects and it taking several minutes after opening Orca/Studio to find it. Any advice, as I’d like to go back to LAN Mode? Cheers
minus-squareZeoic@lemmy.worldlinkfedilinkEnglisharrow-up5·6 days agoI currently have my P1S in LAN mode and use HomeAssistant to control it, using thr ha-bambulab integration. Does everything I need
minus-squareBronzie@sh.itjust.workslinkfedilinkEnglisharrow-up1·5 days agoCheers, HA integration is on the plan for the future, I just strugle with time these days with a small kid and work.
minus-squareBluewing@lemmy.worldlinkfedilinkEnglisharrow-up2·6 days agoRoll back the firmware to a version that worked. You still can do that.
minus-squareBronzie@sh.itjust.workslinkfedilinkEnglisharrow-up1·edit-24 days agoI wish I could. Need the newer FW to use the drying function of the AMS2. I’m considering going back to LAN and just dealing with it though. I really prefer Orca over Studio
minus-squarebluewing@sh.itjust.workslinkfedilinkEnglisharrow-up2·5 days agoIt would appear you are now trapped by Bambu into their product system. May God ha’ Mercy on your Soul.
I did this, but experienced a lot of issues connecting to it afterwards. Constant disconnects and it taking several minutes after opening Orca/Studio to find it.
Any advice, as I’d like to go back to LAN Mode?
Cheers
I currently have my P1S in LAN mode and use HomeAssistant to control it, using thr ha-bambulab integration. Does everything I need
Cheers, HA integration is on the plan for the future, I just strugle with time these days with a small kid and work.
Roll back the firmware to a version that worked. You still can do that.
I wish I could.
Need the newer FW to use the drying function of the AMS2.
I’m considering going back to LAN and just dealing with it though. I really prefer Orca over Studio
It would appear you are now trapped by Bambu into their product system.
May God ha’ Mercy on your Soul.