I need to print some improved tubing connectors, 3 different types - 80 Pcs total, for a pair of crappy shelving units my Wife bought off of Walmart. The originals were as minimal material as possible without missing the nylon tree completely.

The Klipperized Mk3s with a .60mm nozzle is nearly as fast as the mini with a .40mm nozzle. Once again proving it’s not how fast you say you can go, but how fast the parts let you go…

  • Gwingollor@lemm.eeEnglish
    0·
    17 days ago

    Can you explain what the effects are of “Klipperzing”. I know they usually run on Marlin, right? But I’m not sure where the difference actually lies.

    • bluewing@lemm.eeOPEnglish
      1·
      17 days ago

      Yes, Prusa runs on Marlin which isn’t a bad thing, but so does Bambu printers.

      Klipper does a few things for me.

      1. Klipper allows for a lot of customization if you want it. Everything is a text file. And your printer.cfg is easily editable. And is a cheap way to turn your Mk3s/+ into a Mk3.5 for easily under $100US-- depending on what recommended RPi you decide to buy. Accelerometers are dirt cheap. I bought the expensive recommended $20 KUSBA plus a $5 data cable because I didn’t have one. The RPi 4b I already had for years.

      2. It gives the Mk3s a 32bit controller thanks to a Raspberry Pi 4b running the printer now rather than the 8bit RamBo factory board. The RamBo merely relays the moves that klipper tells it to do.

      3. I can now use an inexpensive accelerometer to setup input shaping very easily.

      4. This gives the printer the ability to print faster without a drop in quality. I went from printing 45mm2/sec to 80mm2/sec and accelerations from 1200mm2 to 4000mm2.

      5. This particular conversion is easily reversible in about 10 minutes if I should ever decide I don’t like it. It’s merely a matter of re-flashing the firmware to the RamBo. And reinstalling OctoPrint to the RPi.

      6. This does not mean it’s now as fast as my mini. It’s not and never will be. But it’s far better than it was. For example, in this run of parts, when printing the same part, (identical test connector), with the same filament, the print times are within 10 minutes of each other. The only difference being the Mk3s has a .60mm nozzle installed and the Mini has a .40mm Nozzle installed. I run a .40mm nozzle in the Mini because Bambu optimizes it’s printers specifically for that size. And there is no difference in tolerances and quality. The parts are perfectly interchangeable.

      If you are interested, this is the git hub I used to klipperize my Mk3s